First check the reason for the loose clasp, then do the corresponding treatment; if it is because the screws are loose, then the screws will be tightened; if it is because of the problem of the fixed soft rubber of the shower, then the soft rubber should be replaced; if it is a problem of the fixed seat, the fixed seat needs to be dismantled first, and then reinstall the new one, in order to solve the fundamental problem.
B.What are the precautions for installing the shower?
1, the installation of the shower, the first thing to note is to distinguish between concealed and bright installation, because there are certain differences between the two types of installation. If it is installed in the open, then it is installed two meters from the ground is more appropriate. If it is installed off the ground it is better to have an area of 1.1 metres.
2, to pay attention to the installation of zero line faucet screws, hoses, elbows, bends, straight pipes, slide seat, etc., each part should be fixed to avoid the phenomenon of water leakage later, thus affecting its use.
3, in the installation time also need to pay attention to the distinction between the circuit and the water circuit, to prevent the drilling of holes when the inside of the water pipe will break, so that the phenomenon of water leakage.
4, also need to pay attention to the height of the hot and cold water good statistics to determine good, so that they can be used normally, and their distance error should be less than one centimetre.
5.After the installation is completed, all the dust on the top should be cleaned up to avoid affecting the effect of the water when in use, or leading to the phenomenon of blockage.
6, in the installation of the shower, you also need to pay attention to the safety of the problem, in the installation process do not go to open the water, to avoid a large amount of water on the ground and the phenomenon of falling.